Plug-in thermostat with time switch

The device is a combination of a plug-in thermostat and a time switch, while the function of the thermostat remains even when the time switch is used. The timer can be set for cyclic operation or one-time switching on or off, or one-time switching on or switching off with a delay. Operation is also possible without using a timer.
Specifications:
Power supply 100-250VAC 50Hz
Load 16A (3680W)
Thermostat temperature range: –40°C~120°C
Accuracy ±1°C
Resolution: 0.1°C
Time resolution: 1 minute
Maximum adjustable time period: 99 hours 59 minutes
Maximum deviation: 10 minutes / 100 hours
Possibility of inverse operation - heating or cooling mode
External temperature sensor with 1.8m cable
Setting modes:
The setting modes can be activated step by step with the MODE button
1. Thermostat mode without time programming:
With the buttons SET followed by DOWN and UP, you can set the temperature for switching on and off, while below -10°C and above 100°C can be set with a resolution of 1°C
2: F01 Cyclic on and off mode:
It is possible to set the time when the thermostat is switched on and off. Time periods are set, not real times. Switching on and off is repeated cyclically.
3: F02 Delayed power-on mode:
The switch-on delay can be set in the interval 1 min-99 h 59 min
4: F03 Delayed shutdown mode:
The switch-off delay can be set in the interval 1 min-99 h 59 min
5: F04 One-time power-on and power-off mode
You can set the times after which the thermostat should be switched on and off. After the cycle is over, the thermostat will remain at its default setting

Instructions for use:
1) Insert the thermostat into the socket. The thermostat is only in the mode without time programming and the display shows the real temperature and the set switch-on and switch-off temperatures (preset ON 20°C and OFF 25°C). By briefly pressing the SET button, you can enter the ON and OFF temperature adjustment mode. These can be changed with the UP and DOWN buttons. If the set ON temperature is lower than OFF, the sun symbol flashes above the real temperature reading and the thermostat is in heating mode. Otherwise, the thermostat is in cooling mode and a snowflake flashes on the display. After completing the setting, confirm by briefly pressing the MODE button. A long press of the SET button (5s) can change °C to °F.
2) A short press of the MODE button can activate the timer with modes F01, F02, F03 and F04 (described above). The ON and OFF times can be set with the SET, UP and DOWN buttons.
3) The timer function can be activated by long pressing the MODE button (2s) in the relevant mode F01-F04. Then ON or OFF will flash on the display, depending on the time period the thermostat is currently in. The closed state is also indicated by the blue LED diode.
4) The function of the thermostat is preserved even in the timing mode.