wireless set for 7pin lift with LED lights + magnet

A set of rear, wireless LED lights with a magnet for use in trailers, agricultural and construction machinery.

Properties:

• working hours: up to 20 hours
• range: up to 30m
• power supply: 12V / 24V
• 26 LEDs

The set includes:

• 2 LED lamps with magnet
• 7 PIN plug with transmitter
• USB charging cable
• USB car charger
  
  INSTRUCTIONS:
  To pair, plug the transmitter into the towbar socket on your car.
  Turn on the ignition and depress the brake pedal. Press the power button (white
  button) on the light and hold it until the light flashes 3 times. Same
  repeat the procedure for the second light as well. This time already with it on
  ignition.
  
  Briefly press the power button on the back to turn on the light.
  The light comes on and goes out after a short while. The same procedure applies to
  turning off the world.
  To turn on the license plate light, hold down the power button for 3 seconds.
  
  NOTICE! :
  Before use, check the battery status, if necessary, recharge the lights
  with the included charger.
  Before driving, check the correct operation of the lights.
  If the lights are not in use, once in a while is a precaution
  check, recharge if necessary.
  Lights must be paired before use.
  When using for a long time, check the light once in a while.
  
  At 5V, the battery is fully charged in approx. 2.5 hours.
  The LEDs on the side of the light will show you information about the battery status.
  Data on battery life are only approximate, because it depends on them
  workload and style of use.